Skip to content
Burst pipes

Burst pipe in Ballarat: what to do right now

A burst pipe can put a lot of water through a house in a short time. These steps limit the damage while you get a licensed plumber on the way.

First: stop the water

  1. Turn off the stop tap. In most Ballarat homes it is at or beside the water meter, in a box or pit near the front boundary. Turn it clockwise until it stops. If it won’t move, don’t force it, as an old valve can snap.
  2. Think about electricity. If water is near power points, lights or the switchboard, switch off the affected circuits or the main switch from a dry spot. If you would have to stand in water to reach the switchboard, leave it and keep everyone out of that area.
  3. Drain the pipes. Open a cold tap at the lowest point of the house, such as a laundry tub or outside tap, to let out water still in the pipes.
  4. Turn off the hot water unit if the burst is on a hot pipe or the tank has been drained: switch off the power for an electric unit, or set a gas unit to “off” or “pilot”.
  5. Move valuables and soak up water. Lift rugs, electronics and paperwork off the floor, and use towels and buckets to keep water away from timber floors and plaster.

Is it your pipe or the meter?

The water meter and the pipes on the street side of it belong to Central Highlands Water. If water is coming from the meter itself, the fittings in the meter pit, or the footpath, call their 24-hour fault line on 1800 061 514. A plumber can’t repair the meter.

Everything on the house side of the meter, including garden lines, pipes under the house, in walls and in the roof space, is the owner’s responsibility. That is a job for a licensed plumber. If you can’t tell which side the leak is on, call Central Highlands Water first and describe what you see.

Finding a hidden leak

Not every burst is obvious. Signs of a hidden leak include a damp patch on a ceiling or wall, a soggy spot in the garden that never dries, the sound of running water when every tap is off, or a water bill much higher than usual. A simple check: turn off every tap and water-using appliance, note the meter reading or watch the small dial, and look again after 15 minutes without using any water. If it has moved, water is escaping somewhere.

Why pipes burst in Ballarat

Cold is a big factor. Water expands when it freezes, so exposed pipes on outside walls, under raised floors and in roof spaces can split on a hard frost and start leaking when they thaw. Older copper and galvanised pipes can also fail with age, corrosion or high water pressure, and garden lines get damaged by digging and tree roots. Our frozen pipe guide covers frost protection in detail.

What the plumber will do

Expect the plumber to find the damaged section, make it safe, and repair or replace that length of pipe. For a burst inside a wall or ceiling, they may need to open plaster to reach it. Ask for their call-out fee and how labour is charged before they start, and ask for photos and an itemised invoice if you plan to claim on insurance.

Renting?

A burst water service is an urgent repair under Victorian rental law. Contact your rental provider or agent straight away using the emergency number from your lease, and confirm the request in writing. Consumer Affairs Victoria explains what you can do if they don’t respond.

Need a plumber in Ballarat? Request a callback and we’ll connect you with one or more local tradies, licensed plumbers who cover your suburb.

Request Urgent Callback
Water where it shouldn’t be? Request a callback from a local plumber. Request Urgent Callback